Grasshopper

algorithmic modeling for Rhino

Simple script, small question

Here is a script that I wrote but I am having diffeculties fixing what is happening on the first level on the bottom. Too many shapes stack on top of each here. Here is a screen shot and the script

Views: 333

Attachments:

Replies to This Discussion

Permalink Reply by djordje on June 4, 2013 at 5:50am

Hi Mohanned,
You set the length of your vertical curve as parameter to determine the number of your Rotate axis angles. This resulted in far more rotations than it should.
The definition is ok now.

Attachments:
Permalink Reply by Mohanned Iskanderani on June 16, 2013 at 2:15am

Thank you ! this was very helpful

Permalink Reply by Danny Boyes on June 4, 2013 at 6:15am

Another way of guaranteeing the correct number of rotations is to use the range component.

Permalink Reply by Mohanned Iskanderani on June 16, 2013 at 2:15am

Thank you ! this was very helpful

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service