loft between different shapes

Dear all,

I am new here and i know it would be stupid question ,
but how can i loft a different shapes together , from a square ending with a circle or something. using the series i could manage to loft a number of the same shape.
thank you all.

Replies to This Discussion

Permalink Reply by djordje on May 3, 2013 at 10:39am

Hi Mahmoud,

Apply all of those shapes into a single "curve" parameter (right click on it->Set multiple curves).

Then plug in that "curve" parameter into the "Loft" component ("C" input).

Permalink Reply by mahmoud hammad on May 3, 2013 at 11:25am

Woow.. Thank you so much, that really helped, I am writing my master dissertation about parametric design in towers and was disappointed because I wasn't able to do this !!

Thank you again,
Regards.

Permalink Reply by djordje on May 3, 2013 at 12:20pm

No problem.
It would be nice if you could upload the results of your dissertation, once it's completed.

RSS