remapping numbers

Hi, I would like to break down / remap a list of real numbers (as a result from image sampling) into brackets like

>0.16<0.32 becomes a)

0.0- 0.15 becomes b)

=>0.32 and <0.48 becomes C) and so so

any ideas what would be the best way of doing this?

thanks,

Peter

Replies to This Discussion

Permalink Reply by Danny Boyes on April 2, 2013 at 12:04pm

Hi Peter,

Find Domain component should give you a list of domains that a supplied value is in and then use a List Item Component to get an altered list from 3 possibilities.

First post in a while so I hope its right :)

Permalink Reply by Yoann Mescam (Systemiq) on April 2, 2013 at 12:27pm

Welcome back Danny !

Permalink Reply by Danny Boyes on April 2, 2013 at 1:05pm

Thanks Systemiq,

...anything happen while I was gone :)

Permalink Reply by David Rutten on April 2, 2013 at 12:24pm

[Consecutive Domains] then [Find Domain].

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Danny Boyes on April 2, 2013 at 12:26pm

Hi David,

Long time no write. Small wish for the Consecutive Domain component to have an option to increase the next start by a given amount eg. 0 - 0.16, 0.17 to 0.32 etc.

How was your house hunting?

Danny

Permalink Reply by David Rutten on April 2, 2013 at 12:55pm

Hi Danny,

welcome back. Hope all is well. House hunting should be over, if all goes well we're moving in early June (no tech-support from me that week for sure).

What problem will [0-16, 0.17-0.32, 0.33-0.48] solve?

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Danny Boyes on April 2, 2013 at 1:03pm

At present you can give Consecutive Domain component 0,5,10,15,20 and get

0-5, 5-10, 10-15, 15-20

Sometimes I would like to create a series of Domains like this.

0-4, 5-9, 10-14, 15-19

Where are you moving to?

Permalink Reply by peter on April 2, 2013 at 1:00pm

thanks David / Danny

Have to look into this - on initial test, consecutive domain seems to be jumping one bracket, ie

0.0-0.16 = ok

second one it find is 0.32-0.5 instead of 0.16-0.32

ie. I am feeding a series of numbers into

basically I would like to create sample and image and define a particular value (ie. radius) depending into which bracket the sample point falls and then put a circle with a particualr radius (ie. not a multiplier of the sample value) onto that point ...

thanks again,

Peter

Permalink Reply by Danny Boyes on April 2, 2013 at 1:06pm

Make sure you don't have the Mass Addition option ticked

Permalink Reply by peter on April 2, 2013 at 1:57pm

found it, cheers!

RSS