Grasshopper

algorithmic modeling for Rhino

Perforations Not Going Through

Hi,

I was just wondering why my perforations in this surface don't cut through?

I have read multiple forums and just cannot get it too work. I am new to grasshopper and was just wondering whether someone can look at this to see if i havn't done anything wrong at the start that is causing the holes not to cut through the surface.

Thanks

Views: 229

Replies to This Discussion

Permalink Reply by Hannes Löschke on March 23, 2013 at 4:06pm

In order to have a look, a definition to look at, might help... ;)

Try to bake the perforated surface or change the preview quality (top right corner icon in GH). 99 out of 100 cases, the baked result is ok. GH displays a very rough but fast mesh to handle the possible mass of generated geometry. With this rough mesh holes might look jagged or are not displayed at all...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service