Grasshopper

algorithmic modeling for Rhino

bending once again

hi,

im looking for a way for generating smooth curves, by giving certain pts and then generating a smooth curve. similar to the control points in rhino.

the curves are not planar so its a little bit hard to get them right in rhino. im looking also a for a way to control the weight of the points...

should this be done in kangaroo or by gh components ?

thy !!!

Views: 323

Replies to This Discussion

Permalink Reply by Daniel Coll i Capdevila on February 25, 2013 at 1:42am

Hi, in GH use a 'curve' defined by control points. As I can see from your pic it seems that you are using 3 control points aligned to each other, this will define the tangent at that moment, so it will depend on their distance to make the curve smother of straightener....

Control points weight in GH, use the 'control points' under analysis to get the CPW.

Permalink Reply by Daniel Coll i Capdevila on February 25, 2013 at 3:07am

also try the NurbCurv to control the weights.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service