Insertion of a parameter between multiple connection.

Hey Folks,

I don't know exactly how to word my question. How do you insert a parameter in between multiple connections without re dragging all the lines as shown on the attached. Is there a way of selection the lines and plug into a parameter both ways?

Thx.

Attachments:

parameter storage.JPG, 211 KB

Replies to This Discussion

Permalink Reply by djordje on February 23, 2013 at 3:40pm

Hi ryr,

No there isn't a way. You will have to wire up all panels with the new parameter.

Permalink Reply by ryr on February 23, 2013 at 3:44pm

Thanks djordje,

I thought this would be a basic function of the interface to insert/copy the same kind of parameter from the front and back.

Anyway, it would have been nice. Hope could be found in the later versions.

Permalink Reply by David Rutten on February 23, 2013 at 4:14pm

You create the new parameter, then hold Control and Shift and you can drag all wires from the panel output into the new parameter output. Then you'll still need to hook up the parameter input to the panel output which is now empty.

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by djordje on February 23, 2013 at 4:23pm

Was not aware of that feature.
Thank you David.

Permalink Reply by David Rutten on February 24, 2013 at 4:39am

This is a useful FAQ post:

http://www.grasshopper3d.com/forum/topics/what-hotkeys-and-shortcut...

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by ryr on February 23, 2013 at 4:31pm