Grasshopper

algorithmic modeling for Rhino

Offset planar/non-planar curves. BUG?

I have some curves. One happens to be planar in the XZ-plane. I am trying to offset it in the XY-plane, but no matter what I put into the plane-input, the resulting curves are offset in the XZ-plane.

When I do the same thing with a non-planar curve everything turns out right (it is offset in the XY-plane).

Is this a bug or am I doing something wrong?

I could of course copy the non-planar curve, but then I'd have to make different processing depending on whether the curves are planar or not...

/Simon

Views: 1238

Replies to This Discussion

Permalink Reply by David Rutten on February 20, 2013 at 3:53am

Sounds like a bug. Can you post the curve?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Simon Kallioinen on February 20, 2013 at 4:23am

The curve is actually not planar in the XZ plane, but in a plane similar to the XZ...

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service