Grasshopper

algorithmic modeling for Rhino

Moving a point to the z-axis on the grid?

I asked a similar question and received some awesome answers a couple of days ago. I think they were a bit over my head. I'm kind of looking for the simplest way to do something; I want to move a point to the 0 point in the z-axis. I want the x and y axis to remain untouched. Basically, I want to take a point if it's above the grid, and move it to the grid.

Views: 2772

Replies to This Discussion

Permalink Reply by Kenneth S. McMillan on December 28, 2012 at 10:46pm

Actually, let me go ahead and try messing with this for another day. If I still can't figure it out, I'll post this again tomorrow. I'll leave the topic open for an hour or so just in case someone was already trying to help.

Permalink Reply by Benjamin Golder on December 28, 2012 at 10:59pm

decompose the points into x, y, and z, then use the xyz point component to reconstruct them with a z value of 0 (the default).

Permalink Reply by Benjamin Golder on December 28, 2012 at 11:00pm

or project to plane using the xy plane.

Permalink Reply by Kenneth S. McMillan on December 30, 2012 at 3:19pm

Thanks a lot Benjamin. I was able to use what you said to finish what I was trying to. I really appreciate your help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service