Patterned Surface

Replies to This Discussion

Permalink Reply by Dedackelzucht on November 26, 2012 at 1:46am

-make a surface

-divide it with isotrim

-place a rectangular inside each subsurface

-cull them with true false

-every true rotate 90deg

-take edges ans rectangular and make planar surface

Best Regards

DeDackel

Permalink Reply by Fariz Badi Uzzaman on November 26, 2012 at 3:10am

HI Deda

I got some problem when i tried to place a rectangular shape on my subsurface

i can't make it on the center of my subsurface

can you solve this?

thank you

Permalink Reply by Dedackelzucht on November 26, 2012 at 3:22am

use area to get center of each subsurface and use it as base plane

Permalink Reply by Fariz Badi Uzzaman on November 27, 2012 at 6:33am

but when i use the area, the vector of the rectangle changes like this :

thank you XD

Permalink Reply by Dedackelzucht on November 27, 2012 at 6:53am

If you use just any point as plane reference grasshopper will always put a xy plane to this point. The point cnnot tell the reference plane its directions. In your case it is just enough to put a xz plane between the C output and the P input