mesh repair/eqalize faces

hey guys i genarated a mesh with kangaroo (minimal surface)

is there a way to "clean up the mesh, so there are clean and eqaul faces like in the purple mesh? i want to rebuild the mesh, maybe in kangaroo? the vertices of the faces should have equal lenght.

do you have an idea how to fix this?

thank you so much!

bea

Attachments:

mesh repair.3dm, 1.1 MB

Replies to This Discussion

Permalink Reply by bea franko on November 13, 2012 at 2:34am

and i want to avoid critical points like here:

Permalink Reply by Rémy Maurcot on November 13, 2012 at 3:24am

With Rhinoceros 5, from the surface to try to generate a mesh with the command "_mesh to nubrs."
May be a division of the surface mesh sle help you generate most beautiful and sharp edges.

Permalink Reply by Daniel Piker on November 13, 2012 at 3:33am

It's not generally possible to remove all the irregular vertices (the ones which do not have exactly 4 connected edges) on a mesh with handles like this (see Euler characteristic).

However, I think you could significantly reduce the number of irregular vertices.

It looks like the pre-relaxed mesh comes from a Catmull-Clark subdivision of a triangular mesh, which results in 3-valent vertices at the centres of the triangles. If you rebuild the initial coarse/non-subdivided mesh from all quads then this could be avoided. I think this would be much easier than trying to remesh the surface you have.

Permalink Reply by bea franko on November 13, 2012 at 4:05am

thank you for the replies!

im starting with a nurb, convert this to a mesh. then im doing Catmull-Clark subdivision, after this the relaxation.

im not clearly understanding your advice, sorry.

could you maybe explan or show what you mean?

Attachments:

original.3dm, 213 KB

Permalink Reply by Rémy Maurcot on November 13, 2012 at 4:26am

Sorry for the translation, I use google translation.
The fact is that you generate a triangular mesh, why not stay with a mesh consisting of rectangular meshes that.
If you leave NURBS initially, it is easy to control the mesh with the command "_Nurbs to mesh." With grasshopper you could generate a mesh by using a face component "brep compomant" then "nurbs to mesh."

Permalink Reply by Christian Schmidts on November 13, 2012 at 4:57am