Sweep 2

Replies to This Discussion

Permalink Reply by taz on June 11, 2010 at 12:33pm

In my experience [Sweep2] is very sensitive to curve direction (more so than the Rhino command).

Make sure your sweep curve starts at the beginning of both rail curves.

Permalink Reply by ronyDF on June 13, 2010 at 7:43am

a different description of the problem shows my original question a bit better. the basis for created surfaces is a single [mother] curve.

can you comment pls? thanks.

Attachments:

• Sweep2-v2.3dm, 31 KB
• Sweep2-v2.ghx, 408 KB

Permalink Reply by taz on June 13, 2010 at 5:10pm

You have two sweep curves. The attachment order of the sweep curves matters.

The first sweep curve should correspond to the start of the rail curves. The [Merge2] shows the attachment order that works.

Permalink Reply by ronyDF on June 14, 2010 at 12:13am

thanks, taz. I don't know how to figger this out without your input...
krgds,
Rony