Grasshopper

algorithmic modeling for Rhino

Flatten output and disconnect all

If you right click on the 'D' output of the flatten component and 'deselect all' everything is fine and the data deselects. However, when you reconnect any data back into the 'D' output of Flatten, you no longer get any data output like so:

If you connect a panel to the output D of flatten, you get 'no data was connected'

Attached is the definition that I was using.

Views: 692

Attachments:

Replies to This Discussion

Permalink Reply by djordje on August 14, 2012 at 3:05pm

Hi Michael. Add the "{0}" into the "P" input of your flatten component.

Or you can even delete the "Flatten" component, and instead of that right click on the "point" parameter and check "Flatten".

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service