Grasshopper

algorithmic modeling for Rhino

Hi at all, i divided a surface with a brep section and then the sames curve sholud be used to form the smaller surfaces to paneling the main surface. Well until here there's no problem but when i connect this curves to a surface split the results are a lot of surfaces, trimmed and untrimmed, that are not the results i hoped. While if i bake the curves from the brep and the i select these from rhino the split surface work wonderfully.

Do you know how to oblige gh to work fine?

Views: 1216

Replies to This Discussion

Noone know how is it possible bypass this problem?

RSS

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service