Ecotect and WinAir

I have a proble when I export Ecotect model in WinAir, even if I setted the date at 2006, following the steps in this tutorial:

http://wewanttolearn.wordpress.com/2011/10/12/computational-fluid-d...

When WinAir runs automatically appears this message that I also loaded in the Attach Files: "Problem in initialisation".

I also tried to load the files .con e .geo directly from WinAir, but the program doesn't calculate anything.

Can someone help me?

Attachments:

Cattura.JPG, 157 KB

Replies to This Discussion

Permalink Reply by Francesco Lancio Lanciotti on June 3, 2012 at 11:17am

Ciao!

Mi trovo nella stessa identica situazione :s , data settata al 2006 , tutte le istruzioni seguite....sei per caso riuscita a risolvere?

Permalink Reply by Alessio Erioli on June 3, 2012 at 11:31am

Francesco e Giulia, check this out:

http://www.grasshopper3d.com/group/geco/forum/topics/ecotect-wind-a...

per favore, postate nel gruppo dedicato di a3 (ho trovato per caso questa discussione), così riesco a vedere subito di che si tratta. Se si tratta di un plug-in specifico, postate almeno nel gruppo dedicato al plug-in e non in un post generico, in questo modo avete maggiori possibilità che qualcuno risponda in modo più mirato e più velocemente.

Alessio

Permalink Reply by Scott Penman on June 20, 2012 at 5:37pm

http://forums.autodesk.com/t5/Autodesk-Ecotect-Analysis/Ecotect-and...

BOLEHLAH's message from 04-25-2011 fixed this for me. Basically, instead of running the program out of Ecotect, run it manually - you still have to export out of Ecotect, but make sure "Run WinAir Application" and "Auto-Start Calculation" are UNchecked. Once you've exported the data, open winAIR4 manually, load the geometry and control files that you exported, set your iterations and intervals, and click run.

Permalink Reply by Kiana M on December 29, 2015 at 3:12am