Split points from several lists and make a curves???

Hi,

I divide 3 line into 60 (or random) points.

Now i have to make curves between these points (between divided lines).

But i dont now how to split lists or to collect same points so i can join them.

Like, first points in lists are first curve, second points in lists are second curve, and so on.

List1-List2-List3

1-1-1 first line

2-2-2 second line

3-3-3 third line

4-4-4 ...

5-5-5...

and so on..

Thanks!!!!!!!!!!!!!!!

Replies to This Discussion

Permalink Reply by Dana Zammit on May 1, 2012 at 10:05am

what do you think i should flip? sorry im quite new to gh and have never used this command before

Permalink Reply by Dana Zammit on May 1, 2012 at 11:04am

Hi Milan

This is what i got when i set periodic curve to true. it turned the curves into closed loops

Permalink Reply by Danny Boyes on February 16, 2012 at 2:01pm

HI Milan,

You can also use the Flip Matrix Component found on the Sets Tab > Tree Panel which will change rows to columns and columns to rows of a single separation Data Tree

Permalink Reply by MilanK on February 16, 2012 at 3:04pm

Tnx Danny,
I try your way too, also good
and simpler

Permalink Reply by Dana Zammit on May 1, 2012 at 11:13am

this is what B says:

Permalink Reply by Danny Boyes on May 1, 2012 at 11:21am

that's them. they are not connected to the intcrv component so they will not be used for any curves

Permalink Reply by Dana Zammit on May 1, 2012 at 11:44am

worked!!

last question, promise! :)

why can't i loft these curves? i tried but it lofted the 0-0-0 curve and 11-11-11

Permalink Reply by Danny Boyes on May 1, 2012 at 11:49am

because they are on separate branches. either flatten the input to theloft component or use the shift branches component with a value of -1 to get all the data on one branch

Permalink Reply by Dana Zammit on May 1, 2012 at 11:58am

did it!!! thanks a million i really appreciate your help!! :D

Permalink Reply by Danny Boyes on May 1, 2012 at 12:08pm

why did you need the split list component? i suggest you remove them and just have that wire going into a single entwine component. no need to double up on them

Permalink Reply by Dana Zammit on May 1, 2012 at 12:27pm

i managed...i have quite a few extra things since i wasn't exactly sure what i had to do! will go through it and see what i can erase to clean it up :)