Grasshopper

algorithmic modeling for Rhino

creating line with specific length

Hello,

im new to grasshopper and Im was creating 1 point and after that I want to create simple line with specific length. I know how to create a line, but there I need position of start and end point, and I want to specific position of start point (with x,y,z coordinates) and then I want to specific direction of line and his length, but I dont know how to do this.

Thanks a lot for all your suggestions

Views: 5923

Replies to This Discussion

Permalink Reply by Hannes Löschke on April 6, 2012 at 2:32pm

Did you try the icon right beneath the Line2Pt? It's called LineSDL (which stands for Start-Direction-Length) ;)

Permalink Reply by Ching on April 6, 2012 at 7:03pm

Permalink Reply by Mateusz Zwierzycki on April 6, 2012 at 7:38pm

Permalink Reply by Ching on April 6, 2012 at 7:04pm

Permalink Reply by Ching on April 6, 2012 at 7:05pm

Permalink Reply by Mateusz Zwierzycki on April 6, 2012 at 7:39pm

sry,  couldnt resist to do it ;)

Permalink Reply by Mateusz Zwierzycki on April 6, 2012 at 7:47pm

and to not be considered as troll :

here is a gh file with this example 

Attachments:
Permalink Reply by Ching on April 6, 2012 at 8:00pm

LOL didn't see this coming. Well played sir.

Permalink Reply by Mateusz Zwierzycki on April 6, 2012 at 8:04pm

Permalink Reply by Jozef Vaško on April 7, 2012 at 1:09am

ohh.. im stupid.. its my fault, Im sorry :/

i searched it for half a day and you helped me in 10 minutes.. now I know how to do it, its perfect :)

Thank you very, very much

nice day for all

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service