Paneling uv division problem

I'm trying to align circles to panels, something that shouldn't be to complicated. however, for some reason theres a problem with the uv divide component. It adds extra points where they aren't needed. I've enclosed my definition it would be create if someone could find the problem, because I can't.

Attachments:

help3.ghx, 1.8 MB

Replies to This Discussion

Permalink Reply by Matt Gaydon on February 22, 2010 at 2:29am

Hi Liam

Can you load up the rhino file with the orginal crvs so the definition works as seen in the image.

From what i can see in the Image it seem like you may have duplicate surfaces on the panels that contain extra rows of circles than required.

As well as this some panels seemed to have opposite and UV to others and this is why they look different. though don't know if this is ment to happen.

Matt

Permalink Reply by Liam Morrow on February 22, 2010 at 9:52am

Thanks for the help. Here is the file, the double panels and flipped uvs shouldn't be happening but I'm not sure what went wrong.

Attachments:

help rhinofile.3dm, 23 KB

Permalink Reply by Matt Gaydon on February 22, 2010 at 11:35am

Hi Liam

Your main problem and the reason you got all the double surfaces is the Discontinuity component is giving you a point at either end of the crv. i have fixed this in your defintion just by culling the first point from each list as did not know if the Discontinuity component was important or if both that and the cull could be changed for a end points component and the end point plugged into the srf4pt.

The problem with the random fliped normals is also fixed, this was also linked to there being double surfaces at every point.

i have attached the fixed file

Matt

Attachments:

help3 Fixed.ghx, 2 MB

Permalink Reply by Liam Morrow on February 22, 2010 at 5:34pm

Thanks buddy it all worked perfectly. btw I used the endpoints component, which worked fantastically. I should have thought of that earlier. Thanks again

RSS