Untitled

Attachments:

Untitled-1.jpg, 1.2 MB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by TheChosenOne on October 14, 2011 at 3:17am

Then that the red this is polysurface.

Permalink Reply by EmilianoGH on October 14, 2011 at 3:23am

I obtained it with a 3 curves loft

I can apply voronoi cap3 on my RED?

i have to change some components?

Permalink Reply by TheChosenOne on October 14, 2011 at 7:27am

You can use rhino tools on your polysurfaces, Explode & Merge Surfaces...

Permalink Reply by EmilianoGH on October 18, 2011 at 9:58am

ok, DONE!
But to my surface happens something bad ...

can you take a look at WP_sorgente3.3dm & .gh?

please thank you

Permalink Reply by EmilianoGH on October 14, 2011 at 10:05am

sad sad..sooo sad!

Attachments:

WP_sorgente3.3dm, 509 KB
WP_sorgente3.gh, 15 KB

Permalink Reply by Pieter Segeren on October 14, 2011 at 4:25pm

Hi Ali, I thought I had a good idea, and still think it is. Yet sometimes some curves made from the cells CtrlPts are not aligning correctly even though the Loft align option is ticked (see definition). I don't understand why that is, but I'll ulpoad it anyway, maybe someone can help me/us with that:)

Attachments:

VoronoiCap_st_PSG.gh, 11 KB

Permalink Reply by Yoann Mescam (Systemiq) on October 14, 2011 at 5:20pm

Sometimes the align option doesnt work well, and with different numbers of control points, especially if they "align" badly, loft works weird.

Setting the loft option to rebuild with a good number of CP (100 by example) will give clean results, and lowering the document tolerance in Rhino will make sure the surfaces will still join in one BRep.

Not very satisfying though.

Permalink Reply by Yoann Mescam (Systemiq) on October 14, 2011 at 5:53pm

Not lowering the tolerance of course, getting it higher. Setting it to 0.1 or 0.01 instead of 0.001 by example.

Permalink Reply by Pieter Segeren on October 14, 2011 at 6:06pm

Ah yes, the projections result in a two different point counts, that was it. thanks for the wake up call;)
I think it is very satisfying to get the appropriate responses this fast:) Thanks guys!

Edit: Oh, I seem to be mixing up discussions, I meant: thanks Systemiq:)