Grasshopper

algorithmic modeling for Rhino

Is it possible to change the order in which Grasshopper references geometry?

When multiple geometries from Rhino are referenced (or set) in Grasshopper using (corner to corner selection), it seems like the order of items is set by the chronology of the modification of a single geometry. For example say you create an array of points and reference them in GH, the original point will be last on the list and last of the array first. Say you then move any point and reference them again, the one moved will be the first and the rest will follow in order of modification.

 

Of course, you can also select multiple geometries one by one and reference them in GH in the order of your choice. But does GH use some kind of timestamp on the geometry to sort them, and would it be possible to use eg. the original creation time of the geometry (or any property for that matter), rather than the time when the geometry was modified?

 

Views: 10088

Replies to This Discussion

Permalink Reply by Will Krzymowski on October 6, 2011 at 4:17pm

Actually... if it were a component, it would look something like this (illustrated by the yellow panel)

 

Permalink Reply by Michael Pryor on October 7, 2011 at 11:04am

Merge basically does this already.

Permalink Reply by Michael Pryor on October 7, 2011 at 11:07am

but I think maybe adding a visual type manager to merge component could be convenient.

Permalink Reply by Will Krzymowski on October 7, 2011 at 1:07pm

i probably need to show a clearer example of when this would be of benefit.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service