Why there always some mistakes happen when using "Project"

Replies to This Discussion

Permalink Reply by taz on December 7, 2009 at 12:10pm

If you work only in Rhino and use the Project command with your particular geometry does everything work as expected?

It may be a Rhino problem and not GH...

Permalink Reply by Manuel on December 7, 2009 at 3:17pm

I got this problem too, I just change my curves a little until it works correctly... sorry, thats not very helpful but at least you are not alone.

Permalink Reply by Robert Jason Cross on December 7, 2009 at 4:46pm

have you tried joining all of your curves first?