Objects that disappear

Replies to This Discussion

Permalink Reply by Danny Boyes on July 26, 2011 at 10:43am

Hi Daniel,

 

The issue is data matching. You have several objects and several transformations on different branches.

To overcome this use the Group Component on the Transform Tab > Util Panel to create one group to apply your transformations to.

 

Permalink Reply by Daniel de Berna on July 26, 2011 at 2:03pm

I try  tomorrow...

Thanks a lot

Permalink Reply by Daniel de Berna on July 27, 2011 at 2:41am

Works ok, but the result after creating the series I can not turn it into the mesh, the "tab" turn red and say me there's an error:

"Data conversion failed from group to brep"

Why?

Attachments:

• Immagine.jpg, 354 KB

Permalink Reply by Danny Boyes on July 27, 2011 at 2:54am

Just Ungroup them again after the transform.

Permalink Reply by Daniel de Berna on July 27, 2011 at 3:03am

thanks a lot, but you could explain why I do all these steps?
You would have set the problem differently from the start?

 

Great