Grasshopper

algorithmic modeling for Rhino

Invalid curves and merge component

I was just doing the model and i found out that that i still dont fully understand the way that 'merge' is adding the lists with each other. I need poliline component to produce me as many lines as i multiplyed with the range but somehow only the first one is valid. That might be very easy though!

 

greets

adam


Views: 588

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on May 25, 2011 at 2:07am

If this is the solution you are looiking for...You have to clean your paths (amount) before merging

 

Best Regards

 

DeDackel

Permalink Reply by Adam Chałupski on May 25, 2011 at 2:34am

i was useing clean tree comp but its right - all streems needs to be formated in the same way. Thanks for help, my brain is too tired to figure it out today...

cheers

 

Adam

Permalink Reply by Dedackelzucht on May 25, 2011 at 2:36am
hi, you are welcome! :-)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service