Grasshopper

algorithmic modeling for Rhino

Polyline Curve / Linear Curve

Hello,

 

attached you can see a curve set with 8 curves. They were generated of points. I need the curves all as Polyline Curves and not as Linear Curve but I can't change the position of the points. Is there a possibility to convert them? Thanks alot

 

Flo

Views: 681

Attachments:

Replies to This Discussion

Permalink Reply by Giulio Piacentino on May 24, 2011 at 9:18am

Hi Florian,

it's difficult to say from the picture, but if you know that they are all linear, maybe you could use curve "End Points", then the Line component?

- Giulio
_______________

giulio@mcneel.com
McNeel Europe

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service