algorithmic modeling for Rhino
Hi there, I am trying to get lines to extrude at a tanget to the surface, no matter what angle it is. I connot figure this out so any help is much appreciated :)
Thanks
Tags:
I found that if I sweep to create the surface it is fine, but if I loft it it turns out like it does above... Weird.
Extruding it before morphing it def makes it extrude tangentially, which is what I wanted so thank you again Danny !
1) The UV directions for the Loft are 90 degrees out to the UV directions of the Sweep method. So you would need to alter your definition accordingly.
2) Glad to here it, you're welcome.
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by