Blend Shape

Replies to This Discussion

Permalink Reply by oliver von Malm on October 14, 2009 at 5:42am

Hey Shankar,

Here is one that I just wrote for curves. Maybe it'll help you and you can convert it for surfaces or similar...

greetings, oli

Attachments:

• BlendShape.ghx, 130 KB

Permalink Reply by Suryansh Chandra on October 14, 2009 at 11:46am

Whats the geometry type you are looking for? I remember covering Curves and Surfaces with you guys. Maya's blend explicitly works for Meshes. It can be coded for GH as well, the rules would remain the same as in Maya:

1) number of vertices on the source and target should be identical

2) order of vertices should also be identical -- for this reason, when blending in Maya, one often ends up copying the source shape and modifying it to generate the target shape rather than modelling it from scratch -- just to make sure that order of vertices remains the same.

If you are indeed looking for a definition that works with Meshes, this methodology should work for you:

1) get vertices of source and target (count and order should match)

2) get the vertices for each face of the mesh (identifying the index of vertices that create a face. For Rhino, they will either be 3 or 4)

3) draw lines between source and target vertices.

4) sample one point on every line based on the blend amount. Implying that a 50% value would give you the midpoint on each line, 0 would give the start point, and 100% would give the end point.

5) these new points are the vertices of your desired shape. use the information you generated in step (1) to recreate mesh faces.

Permalink Reply by Suryansh Chandra on October 14, 2009 at 12:10pm

Just did a quick definition for the same. Attached.

Attachments:

• Mesh_Blend.zip, 18 KB

Permalink Reply by ILIAS on December 16, 2011 at 10:25am

Thank you for sharing! it´s simple but very effective!