Basic steps for Voronoi flat object creation.

Replies to This Discussion

Permalink Reply by Chris Tietjen on May 4, 2011 at 10:36am

How about this?  Just place some points on the XY plane in Rhino and instantiate them into the point parameter component using the set multiple points option.  The offset distance has been made negative with an internal expression in the offset component.

Chris

Attachments:

• simpleVoronoi.ghx, 108 KB

Permalink Reply by Jim Davies on May 4, 2011 at 10:48am

That looks very similar to what I was after.

 

Thank you Chris

 

Jim

Permalink Reply by Jim Davies on May 5, 2011 at 5:17am

Hi Chris,

I have played a bit with your file. It was great to start with and I have progressed a little.

As you can see I have created the surfaces as needed but how can I limit the outer border to be a rectangle for example?

Thank you

Jim

 

 

 

 

 

 

Permalink Reply by Jim Davies on May 5, 2011 at 5:18am

I need the outer shells to be restricted by that rectangle and end there.

 

Jim.

Permalink Reply by Dedackelzucht on May 5, 2011 at 5:27am

are you looking for this?

Attachments:

• simpleVoronoi_DeDackel.3dm, 44 KB
• simpleVoronoi_DeDackel.ghx, 107 KB

Permalink Reply by RWNB on May 5, 2011 at 5:28am

create a box comp (in Params -> Geometry) and define your border.

Permalink Reply by Jim Davies on May 5, 2011 at 5:39am

Thanks guys !!!

 

Visually looks great. I will test it.

 

Jim