Hair Dynamics

Replies to This Discussion

Permalink Reply by Ángel Linares on April 24, 2011 at 4:47pm

http://vimeo.com/22811435

 

Something like this? With kangaroo is not hard...In this video "hairs" atrack each other too but could be deactivated...

 

Best Regards.

 

 

Permalink Reply by Matthew McFetridge on April 25, 2011 at 12:22am

Thanks! This is great stuff. I have had a look at the thread you created and have done this. What I want to do is have all the connecting lines attract to each other. When I do this with the base lines (the ones you created it works) but when I get the end points and connect those lines to every other point it doesnt?

 

What I am trying to achieve is what Shampoo does at about 36 seconds in of there video that I posted above

 

Thanks for any help in advance

Attachments:

• Optimizing Path Dynamics.3dm, 42 KB
• Optimizing Path Dynamics.ghx, 243 KB

Permalink Reply by taz on April 25, 2011 at 7:13pm

Have you seen the demonstration file included with the Kangaroo download?

http://www.grasshopper3d.com/forum/topics/horizontal-woolly-paths-help

Permalink Reply by Matthew McFetridge on April 27, 2011 at 4:41am

Yes I did thank you. What I want to do is do what the example file does but to lines created through cross-referencing them.

Like the SS below, although I get an error.

Note: The file attached does work, It may just take a few minutes to compute (depending on the speed of your computer). So just wait for it to load

Attachments:

• Bundling Matthew Edit.ghx, 147 KB