Grasshopper

algorithmic modeling for Rhino

extracting border geometry

Hi,

Does anyone have suggestions for how I could go about extracting the border curve from a surface? I'm assuming there's no equivalent command for Rhino's "dupborder" in GH.

Thanks

Views: 873

Replies to This Discussion

Permalink Reply by Manuel on September 16, 2009 at 1:20am
Surface -> Analysis -> BRep Component (Explode), then list item component in the edge output to get the curve that you want.
The wireframe component should work too...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service