Grasshopper

algorithmic modeling for Rhino

Normal to surfaces

Hi guys,

I have this list of surfaces an I want to apply rectangles (that will be holes) on these surfaces. The holes on the surface are growing in size going farther from the attraction point, but there is less in less holes going farther from the attraction point.

The problem is that my rectangles aren't in the right angle. I would like them to be perfectly on the face, tangent to them. So I tried with surface normal components, but I can't make it work.

I would be really gratefull if you can help me.

Thank you!

Philippe

Views: 284

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Chapulin Colorado on October 9, 2017 at 2:08pm

HI,

without your definition its a bit hard to say, maybe this could be a way:

Permalink Reply by Philippe Vezina on October 9, 2017 at 2:30pm

Here's the script 

Attachments:
Permalink Reply by Jack lee on October 11, 2017 at 4:16am

try this way

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service