Grasshopper

algorithmic modeling for Rhino

Irregular triangulations?

Hello Everyone, 

I am trying to achieve something similar to reference image. 

Also attached is the results of the what I have managed so far in Grasshopper. 

What is the best way to achieve irregular triangular grids on a planar surface? 

If anyone can share their two sense that would be really helpful. 

Thanks

Views: 621

Attachments:

Replies to This Discussion

Permalink Reply by Petras Vestartas on September 30, 2017 at 3:33am

I suggest to re-mesh base mesh with kangaroo mesh machine by attract points.

In that way you will achieve irregular triangulation.

Or use attractor points to scale the grid.

Permalink Reply by DILIP MISTRY on September 30, 2017 at 4:51am
Thank you Petras for your suggestion. I am going to give it a try. Still learning grasshopper and have never used kangaroo. I created the base grid using lunchbox.
Permalink Reply by DILIP MISTRY on September 30, 2017 at 10:02am

No luck with Kangaroo. Being a newbie i cannot figure out how to use it.

Any other suggestions is welcomed.... 

Permalink Reply by Petras Vestartas on September 30, 2017 at 10:58am

How to use mesh machine is very well explained here:

http://www.grasshopper3d.com/forum/topics/multiple-breps-with-meshm...

From food4rhino download kangaroo 1 not second version for remeshing

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service