Grasshopper

algorithmic modeling for Rhino

Warped Floor Slabs

Hello All,

 

I would like to model a warped floor slab similar to SANAA's Rolex Center.  My principal criteria:

1) maintain a fixed perimeter footprint

2) maintain a uniform slab thickness

3) control y-axis variations anywhere along the slab

4) cut out holes from the slab

 

The goal is to "lift" a slab of uniform thickness at different places in the plan.  I'm not sure  if it is better to think of the lifted areas as contours.?

 

I would appreciate any advice.  Thank you.

Views: 1147

Replies to This Discussion

Permalink Reply by Chris Tietjen on March 11, 2011 at 12:46pm

Don't you mean control Z-axis variations?  Controlling Y-axis variations seems to violate premise 1)Maintain a fixed perimeter.

 

Chris

Permalink Reply by Matthew Schexnyder on March 11, 2011 at 1:31pm

Hi Chris, Thanks for your question.  To clarify, I did intend to say "Z" axis.  I know this is probably a straight forward operation for those with experience using grasshopper, I'm just having trouble getting started.  Did you have any thoughts on an effective way to proceed?

 

Best Regards, Matthew 

Permalink Reply by owen wilson on March 11, 2011 at 1:56pm

hey,

 

this might be a very basic(wrong) answer but could you:

 

1) draw the plan curves in rhino

2) make the slab in grasshopper using those curves as the base geometry

3) then u can adjust the original curves in rhino and the whole definition will respond

 

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service