Create circles in gradiant radio

Hello!

I wanna create cicles in the Yaxis. I wanna start from one diameter and increase it, so the smallst is down and up the bigest one. The thing is that the centers of the circles should not be equidistant, otherwise them overlap themself.
I use the bubble move like:
G: fisrt circle
T: Unit Y vector= domain+range+unitY
But the problem is that are all of them equal, same distance

How can I increase it gradually?

Thanks a lot!

Replies to This Discussion

Permalink Reply by Dedackelzucht on March 11, 2011 at 12:40am

hopefully this helps :-)

Best Regards

Dackel

Permalink Reply by Dedackelzucht on March 11, 2011 at 12:40am

upps file missing

Attachments:

Create circles in gradiant radio_Dackel.ghx, 107 KB

Permalink Reply by Miguel Angel Diaz Gonzalez on March 11, 2011 at 1:30am

Thank you very much!

Just one question, is it complete?like in the image, because I have grasshopper 6, and it´s made in 8, and when I open says: "you have an old version...."

What should I connect to what???

Thank you again!

Permalink Reply by Miguel Angel Diaz Gonzalez on March 11, 2011 at 1:34am

Sorry, I forgot the file...

Permalink Reply by Dedackelzucht on March 11, 2011 at 1:36am

oh, there is missing a lot

hopfully it works

Permalink Reply by Miguel Angel Diaz Gonzalez on March 11, 2011 at 1:50am

Ok!Thanks, I creat it by my self. Just one question, what is the bubble Ins?I cannot find it.

thx

Permalink Reply by Dedackelzucht on March 11, 2011 at 1:52am

List Insert

Permalink Reply by Miguel Angel Diaz Gonzalez on March 11, 2011 at 2:09am

Thanx Dedackelzucht! The problem is that in my Grass I don´t have List Insert....But maybe you can help with my definition:

As you see the problem is that now, my circles overlap them.....And other thing, is that the first circle must be with this radio (r=3cm)

I use the range, because I try to delimit the circles into the measure of the fassade. Then I copy in the Xaxis, but this isn´t difficult

Thx

Permalink Reply by Miguel Angel Diaz Gonzalez on March 11, 2011 at 2:10am

File missing....

Permalink Reply by Miguel Angel Diaz Gonzalez on March 11, 2011 at 2:53am

I have the final question, I think

-I have one circle radius (R) = 3cm

-and I wanna copy it in the Yaxis with a movement of the center like: m=3*R (the one before). So the function could be m=(3^(n-1))*R1 (n=position of the new point and R1=first radius=3)

-and radius i wanna 1.5 times the befores radius Rn=((3/2)^(n-1))R1

...so how can I do this...to copy many times with this movement??

Thank you very much!

Permalink Reply by Chris Tietjen on March 11, 2011 at 12:35pm