merging surfaces to a single surface

HI...........HI I AM TRYING TO CONVERT MULTIPLE SURFACES INTO A SINGLE SURFACE ....

SO THAT I CAN SUBDIVIDE IT IN GRASSHOPPER AND APPLY SOME SORT OF PATTERN OVER IT.....

Attachments:

profile and massing 4.3dm, 871 KB

Replies to This Discussion

Permalink Reply by David Rutten on September 2, 2017 at 8:27am

You can use the _MergeSrf command with the Smooth=No option. However if you can create the surface cleanly from first principles, that would be better. MergeSrf results in a surface with stacked internal knots. This can cause problems further down the line.

Permalink Reply by MANU on September 2, 2017 at 2:02pm

yeah ...... i have already tried mergesrf..... but it creates problem in grasshopper when i try to subdivide the surface ..... the file becomes heavy...

Permalink Reply by David Rutten on September 2, 2017 at 4:00pm

I can't figure it out either. You'd think that curves this similar could be easily converted into a clean nurbs-surface, but every command I try just generates a mess. I didn't manage to get it to work through code either. It almost worked, but the surface I generate deviates from the narrow arcs in the middle section.

Permalink Reply by MANU on September 3, 2017 at 12:26am

thanx ........ for the help

Permalink Reply by David Rutten on September 3, 2017 at 2:50am

I've put this problem on our internal slack channel, let's see if any of the Rhino tech experts have any ideas.

RSS