Grasshopper

algorithmic modeling for Rhino

delete Overlapping lines

I want to delete overlapping lines, when delete lines, as well as a corresponding set of data to will be deleted according to delete the line, so I want to delete CULL PATTERN.

As shown in the figure, I would like to get lines: 0 or1, 3,4,5,7,9,11.

line 0 and line 1 have the same length.

line 2 and line3 have the same start point,so 6 and 7 ,8 and 9...

A line only overlaps with  one line at most

Views: 1156

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 17, 2017 at 1:07am

Not sure one of these could be a general solution, anyway..

Attachments:
Permalink Reply by chu on August 17, 2017 at 1:31am

nice,thanks you very much.

Permalink Reply by Raul Matagringo on August 17, 2017 at 1:47am

Hi,

maybe like this one?

Cheers,

Raul

Attachments:
Permalink Reply by chu on August 17, 2017 at 7:30am

thanks for your reply.

your solution did not work correctly ，there are still have duplicate lines.

 

 

Permalink Reply by Raul Matagringo on August 17, 2017 at 8:55am

Thats true,

the solution was the simplest one according to your first picture (just two lines are overlapping). So i didn't do further checks.

Kims solution may be the better choice.

Permalink Reply by chu on August 17, 2017 at 9:25am

en, i'll still thanks you for your help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service