multiple attractor points

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 13, 2017 at 9:07am

Hi.

Check attachment.

Attachments:

• pattern_reV1.gh, 18 KB

Permalink Reply by faya on August 13, 2017 at 9:58am

thank you so much!

Permalink Reply by faya on August 14, 2017 at 12:34am

Hi Kim, followed your algorithm but the extrusion goes on both sides?

Permalink Reply by Hyungsoo Kim on August 14, 2017 at 12:50am

In your eyes it's both side extrusions? Did you check the attached file? Try again.

Permalink Reply by faya on August 14, 2017 at 1:10am

i did it again as your algorithem  n it goes both sides

Permalink Reply by faya on August 14, 2017 at 1:17am

i ve tested your file as well and does the same extrusion I mean on both sides

Permalink Reply by faya on August 14, 2017 at 1:09am

indeed I am looking to have building in my site plan from 1 up to 25 floor and I want them look like he attached image... any comments that helps me, I do appreciate

Attachments:

• torsion_4_1.jpg, 150 KB