Grasshopper

algorithmic modeling for Rhino

Make a rectangle around a centre

Hey!

I have a problem. I create points, which I want to use to create rectangles. My problem is, that these point should by the centre of my new rectangle. But now I'm not sure how long the edges should be. So my question is there any possibility to create rectangles around a centre?

Thanks Bonobert

Views: 5374

Replies to This Discussion

Permalink Reply by David Rutten on July 1, 2017 at 6:16am

Just the [Rectangle] component will create a rectangle on a plane. As long as you set your X and Y intervals to go from -a to +a and from -b to +b (where a is half the desired width and b is half the desired height), you'll end up with centred rectangles.

Permalink Reply by David Rutten on July 1, 2017 at 6:18am

See attached.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service