Grasshopper

algorithmic modeling for Rhino

Panel round off numbers unwanted

Hi, 

I have a question. After putting an integer division in my model, I wanted to check if the output was correct. Then I noticed that the uitput in the panel is round off. I would like to have the exact number. Does anyone knows how I can fix this? I hadn't have this problem before. 

Thank you!

 

Views: 313

Attachments:

Replies to This Discussion

Permalink Reply by Joe Allberry on May 25, 2017 at 3:59am

You're using the "Integer Division", which will auto round the results. "Division" component will give you the full result I think you're looking for.

Permalink Reply by Sue-Ellen de Nijs on May 25, 2017 at 6:52am

Thank you very much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service