Trimming issuse

Replies to This Discussion

Permalink Reply by Chris Tietjen on March 3, 2011 at 11:00pm

I had to use a boolean difference to get the holes (instead of a trim) which meant making your input Brep a solid (ie. adding a cap).  I also pushed the blocks down through the bottom surface to get a good intersection.  Then it was just a matter of turning off a lot of duplicate surfaces that were occluding the view through the holes.

Hopefully none of that disturbed your original intent.

 

Chris

Attachments:

• finalscript.ghx, 382 KB

Permalink Reply by jeffrey Kaufman on March 4, 2011 at 8:37am

thank you so much,!!!!