Grasshopper

algorithmic modeling for Rhino

Lofting a set of irregular curves derived from planar surfaces.

Hi all, I am trying to create a smooth outer loft surface for a set of irregular shaped curves that are derived from planes.

I've tried using Rail Revolution, tweaking loft options, and tried all examples I could find online but none works. It still leaves a kink where the structure was cut.

Many Thanks!

Annie

Views: 584

Attachments:

Replies to This Discussion

Permalink Reply by Birk Binnard on April 27, 2017 at 9:55am

Just a guess - but many Loft problems result from control curves not having a consistent direction. So  check that and see if it fixes things.

Also - it's always best to post your GH file here so people can see what's really going on. Post the associated Rhino file too if the GH file depends on one.

Permalink Reply by Annie Wu on May 1, 2017 at 8:33pm

Thank you very much! It is true that the part where the spheres cut, the curve directions changes, but I'm not sure how am I suppose to fix it...

Sorry I should've posted my grasshopper file!

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service