Grasshopper

algorithmic modeling for Rhino

Bending curves based on geometry

Hi there,

Hopefully you could advise me a bit on my idea.

I have a geometry (sphere in this case) which partially sticks through a series of vertical lines. What I like to achieve is that the series of lines (only the onces that will touch the sphere) will bend around the left side of the geometry. They should bend in their own axis. 

The vertical lines here should bend around the sphere on the left side.

I look forward towards some advice.

Thanks in advance.

Best,

Remy

Views: 826

Attachments:

Replies to This Discussion

Permalink Reply by kevin sun on April 24, 2017 at 9:13pm

this?

Permalink Reply by Remy Konings on April 25, 2017 at 3:34am
Indeed, like that. Great! Except i guess, as i look at your picture, that the width of the beams are even in the curve right?
Permalink Reply by Remy Konings on April 25, 2017 at 3:35am
Are not even in the curve*
Permalink Reply by Remy Konings on April 25, 2017 at 3:38am
I guess what i meant to say is that it is not a very natural curve
Permalink Reply by Michael Pryor on April 25, 2017 at 12:50pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service