algorithmic modeling for Rhino
3d curved surface to flat
I have created a complex set of 3d curves and I would like to attach adhere a skin to one side of each of the curves. Do to the nature of the skin I need to cut it out of a flat sheet. Is there a simple way in kangaroo to create a flat from the 3d covered surface? I have tried to use the rhino command “squish” any other ideas.
type of curves i am trying to put film on one side
Views: 989
Replies to This Discussion
-
Permalink Reply by John on
-
First Kangaroo works with meshes.
If you convert these stripes to develop-able mesh stripes you can unroll with kangaroo stripper component.
As long as these are just some loft surfaces, rebuild them to developable surfaces and unroll with either rhino unroll function or similar component from gh.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
-
Contour Chair
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
