Grasshopper

algorithmic modeling for Rhino

Loft Won't Follow Arc

I am lofting a building and where there is an arc it will not follow it. Instead it jumps to the center point of the arc creating a very sharp corner.

Do i not have enough point on it or something?

Built it with a PLine in rhino then attached the GEO node then moved with a series for the usual steps and floor heights. Attached after the move is the LOFT. Followed all straight lines but one hit arc it shortcuts to center and back instead of following the curve (Arc).

Views: 459

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on March 10, 2017 at 3:27pm

Post your code?  Did you try 'Display | Preview Mesh Settings | High Quality'?  That might be nothing more than a low quality rendering anomaly?

Permalink Reply by Chris Fitch on March 10, 2017 at 3:44pm
Tried the control changes and nothing changed.

It wont let me attach anything after the first post. am i missing something.
Permalink Reply by David Rutten on March 10, 2017 at 4:10pm

There's a 5MB upload limit.

But it does look like a meshing issue. If you bake the surfaces, does Rhino show them correctly?

Permalink Reply by Chris Fitch on March 10, 2017 at 4:14pm
Bake did not work.

I know the size max but there is no option to attach anything at all on the reply.
Permalink Reply by Joseph Oster on March 10, 2017 at 5:01pm

Did you try "Upload Files" below the post editor?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service