Grasshopper

algorithmic modeling for Rhino

Divide Domain for irregular shaped surface

Hi everyone, i am going nuts with this problem and really need help. Not too sure why this is happening but was wondering if there was a solution for this. I am trying to divide domain for a surface which has more than 4 sides. However as you can see it does not seem to distribute the grid to fill the surface properly.

Views: 1849

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 15, 2017 at 11:21am

Hi,

Check attached. Best.

Attachments:
Permalink Reply by phing seow on February 15, 2017 at 8:23pm

many many manythankS!!!!!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service