Can you set BlendCrv continuity to G3?

Replies to This Discussion

Permalink Reply by David Rutten on December 23, 2016 at 4:19am

No, the Rhino SDK does not provide blending for higher continuities. It's probably something we can add, but not before Rhino6 is released officially I suspect.

Permalink Reply by M on December 23, 2016 at 4:42am

I see, that's unfortunate. But I'll make do with G2 curves for now. I won't be able to wait for R6 so I'll just have to deal with it.

Permalink Reply by M on December 23, 2016 at 5:39am

In the end the biggest cause of the problem was indeed not the BlendCrv but a Rebuild block that was left over somewhere. The problem is now solved, there's still a lot that can be improved, but I'm sure that this can be done with playing around with parameters.