Node issue with exoskeleton plankton and cytoskeleton not running

2016-11-23%20%281%29.png

Hi Daniel, Thanks for the script it's fantastic,

I guess this is too anyone who can give me some advice, I am a real beginner with grasshopper and just trying to jump into the deep end and get exposed. I have structure which is piped correctly but there are no nodes appaering. I managed to download exoskeleton correctly and Topolizer. Unfortunately when I open grasshopper the cytoskeleton does not open (runs error codes) I have also tried Plankton as I read the scripts coexist but no luck i dont see plankton appearing in mesh toolbar. Do you think the reason the Nodes aren't working is a maintenance issue or a scripting issue ?

Best

Drew

Attachments:

2016-11-23 (1).png, 519 KB

Replies to This Discussion

Permalink Reply by David Stasiuk on November 23, 2016 at 7:33am

A couple of things: you're feeding polylines into Exoskeleton, and it requires simple lines, so you should explode your polylines. You also should make sure you feeding it a flat list...Exoskeleton will split its operations according to data structure.

Permalink Reply by Drew yates on November 23, 2016 at 8:19am

Hi David thanks for your swift response,

I did explode the lines prior to plugging it in also the i have also tried flattening the list. I believe all the lines are joined at the points.

Permalink Reply by David Stasiuk on November 23, 2016 at 11:00am

In that last image you're feeding polylines directly into Exoskeleton...it would be easier to show you if you upload your file (with internalized curve geometry)

RSS