Convert untrimmed surface to trimmed surface

I have some geometry which I want to run through some environmental analysis software (DIVA). Problem is some of my surfaces are untrimmed, as a result DIVA doesn't seem to be reading those surfaces.

I've tried for hours to find a way to convert from untrimmed surface to trimmed surface to no avail. Does anybody have any suggestions?

I've attached my gh file (the untrimmed surfaces are the previewed surfaces)

Thanks,

Rauland

Attachments:

portable.gh, 93 KB

Replies to This Discussion

Permalink Reply by Andy Lee on November 21, 2016 at 11:28pm

Hi Rauland and everyone!

I am facing the same problem with Rauland and I also tried the solutions that Tom suggested but it still did not work. How about your case, Rauland? Have you find out a way to overcome your problem?

I attach my file here, could you guys please look at it and guide me how to solve this trouble? Any help would be much appreciated!

Thank you in advance
Best regards,

Andy

Attachments:

Reunited (Metter)_Multi direction_HBLB.gh, 520 KB

Permalink Reply by Andy Lee on November 22, 2016 at 11:48am

Anyone here can help me please, I have tried for hours to find a solution but it's hopeless now. With this trouble, I can not run the simulation using Ladybug or Honeybee. I am just a beginner in Grasshopper so please help me!!!
I am looking forward hearing from you soon!!!!!!!!

Andy

RSS