Grasshopper

algorithmic modeling for Rhino

Rotate Lines Based on Graph Mapper?

Hello everyone! Im facing an issue right now:

I have got a series of points, a grid of points. Then certain rows of points get recreated by the values of a graph mapper. So I need to rotate the right lines in the direction of these points.

Just like this:  Connecting the points with a polyline will not do because the lines will vary in length, which is not intended.

Thanks for any insight!

Views: 695

Attachments:

Replies to This Discussion

Permalink Reply by ShynnSup on November 7, 2016 at 7:53am

Any ideas?

Permalink Reply by Christian Gartland on November 7, 2016 at 9:53am

If what you're trying to achieve is a set of lines all with the same length, this may be what you're after:

Essentially, you need to take a segment, 4.33m in length, from each of the exploded segments given from the polyline. 

Permalink Reply by ShynnSup on November 7, 2016 at 9:01pm

Alright thanks! I tried to replicate the procedure, but Im doing something wrong, could you upload a broader screenshot please?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service