Grasshopper

algorithmic modeling for Rhino

how to create a mesh in orthogonal grid from a brep

I'd like to create mesh in orthogonal grid from 2 brep surfaces as shown below, each mesh is 10x10m:

however, I got the following using the mesh brep component:

May I ask how to adjust the settings of meshing to get the orthogonal mesh I intended?


Thank you!

Views: 1016

Attachments:

Replies to This Discussion

Permalink Reply by Grasshope on October 8, 2016 at 12:08am

any suggestions, guys?

The brute force way is to draw a grid of evenly spaced horizontal and vertical lines and use them to slice the surfaces. But I wonder if there is an efficient way to generate orthogonal meshes from brep.

Appreciate your advice!

Permalink Reply by Mohamed Naeim on October 8, 2016 at 3:22pm

Did you try the weaverbird plugin ( mesh from lines)?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service