Sweep 2 problem

Replies to This Discussion

Permalink Reply by Armin Seltz on October 7, 2016 at 9:07am

Sweep2 is a bit of a tricky one and I think you actually want another component in this case. You can use "edge surface" and specify the 4 edges:

Permalink Reply by Michele Di Martino on October 7, 2016 at 9:12am

thanks Armin, sorry but i'm new in the gh world :)

Permalink Reply by Armin Seltz on October 7, 2016 at 9:33am

No need to be sorry! We all started once ;)

Permalink Reply by ng5 Alex on October 7, 2016 at 9:17am

Hello Michele,

in the case of sweep 2 you need the following

the rails are the surface edge curves you have selected. in these two rails one of the two lines gets sweeped to output the surface. but one edge curve needs to be flipped so both rails have the same direction.

best

alex