Grasshopper

algorithmic modeling for Rhino

Perforate holes pattern automate and opening area use by Grasshopper

Hi , I am a new user with Grasshoper and Rhino . I would like to create a multipanels with a border 10 mm each sides of panel and a perforate holes 8mm inside opening area is 48% . Anyone in here can help me out ???? Many thank

I had try to make 1 panels under this pattern perforate but it was give me a wrong result of area opening.

Views: 645

Replies to This Discussion

Permalink Reply by Michael Weizmann on August 23, 2016 at 7:37am

Hi,

Try taking the points from 'P' output of 'TriGrid' and connect to circle instead of using 'Control points' component.

'CP' returns you lots of duplicate points that you don't need

Permalink Reply by Chang dang on August 24, 2016 at 4:27am

thank you Michael , how can we offset a surface panels if i would like to have a border on this panel ????

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service